中国农业科学 ›› 2026, Vol. 59 ›› Issue (22): 5206-5216.doi: 10.3864/j.issn.0578-1752.2026.22.017

• 食品科学与工程 • 上一篇    下一篇

pH偏移处理对大豆分离蛋白-细菌纤维素共聚体形成及热诱导凝胶动态过程的影响

余远方(), 丁超, 庄昕波()   

  1. 南京财经大学食品科学与工程学院/江苏省现代粮食流通与安全协同创新中心, 南京 210023
  • 收稿日期:2026-03-25 接受日期:2026-09-03 出版日期:2026-11-16 发布日期:2026-11-19
  • 通信作者:
    庄昕波,E-mail:
  • 联系方式: 余远方,E-mail:1204857297@qq.com。
  • 基金资助:
    国家自然科学基金青年基金(32302124); 江苏高校优势学科建设工程资助项目(PAPD)

The Formation of Soybean Protein Isolate/Bacterial Cellulose Co- Assemblies and the Dynamic Process of Heat-Induced Gelation

YU YuanFang(), DING Chao, ZHUANG XinBo()   

  1. College of Food Science and Engineering, Nanjing University of Finance and Economics /Jiangsu Modern Grain Circulation and Safety Collaborative Innovation Center, Nanjing 210023
  • Received:2026-03-25 Accepted:2026-09-03 Published:2026-11-16 Online:2026-11-19

摘要:

【目的】从微观结构与分子构象层面,系统阐明pH偏移处理调控大豆分离蛋白(SPI)-细菌纤维素(BC)共聚体形成及其热诱导凝胶化动态过程的机制,为高性能蛋白-多糖复合凝胶材料的开发提供理论依据。【方法】将SPI分散液调至pH 2.0,加入BC充分搅拌后回调至pH 7.0,构建SPI-BC共聚体。采用粒径分析、表面疏水性测定,激光共聚焦显微镜(CLSM)及低场核磁共振(LF-NMR)等手段,系统探究SPI-BC共聚体形成过程和热诱导凝胶动态变化规律。【结果】pH偏移处理驱动SPI经历“解折叠-再折叠”动态过程:在酸性条件下,SPI因静电斥力作用由紧实球状结构展开为无规则卷曲构象;加入BC充分搅拌并回调至中性时,BC被有效包埋于SPI分子间,抑制其构象恢复,形成稳定的熔球态SPI-BC共聚体。该共聚体的粒径显著增大至270 μm、表面疏水性显著提高至6 233。热诱导过程中,SPI-BC共聚体凝胶初始温度显著低于天然SPI,储能模量在70 ℃即开始急剧上升。CLSM观察显示,天然SPI热诱导凝胶需要经历先结构展开然后交联形成三维网络凝胶的过程,SPI-BC共聚体热诱导凝胶为直接交联形成致密、均匀的三维网络结构。LF-NMR结果进一步证实,SPI-BC共聚体凝胶中不易流动水的弛豫时间最短(75.64 ms),表明致密的凝胶三维网络结构和水分子束缚能力呈正相关关系。【结论】pH偏移处理可通过调控SPI分子构象转变,促进其与BC缠绕形成稳定共聚体,该熔球态共聚体在热诱导过程中直接交联形成结构致密、分布均匀的三维凝胶网络。

关键词: 蛋白-多糖互作, 分子构象, 微观结构, 凝胶特性, pH偏移处理, 熔球态共聚体

Abstract:

【Objective】 From both the microstructural and molecular conformational levels, this study aimed to systematically elucidate the mechanism by which pH-shifting treatment modulates the formation of soybean protein isolate (SPI)-bacterial cellulose (BC) co-assemblies and their subsequent heat-induced gelation dynamics, with the goal of providing the theoretical guidance for developing high-performance protein-polysaccharide composite gel materials. 【Method】 The SPI dispersion was adjusted to pH 2.0, mixed with BC under continuous stirring, and then readjusted to pH 7.0 to construct SPI-BC co-assemblies. The assembly process and the dynamic changes during heat-induced gelation were systematically investigated using particle size analysis, surface hydrophobicity measurement, confocal laser scanning microscopy (CLSM), and low-field nuclear magnetic resonance (LF-NMR). 【Result】 pH-shifting treatment drove SPI through an "unfolding-refolding" dynamic process: under acidic condition, SPI transitioned from a compact globular structure to a random coil conformation due to electrostatic repulsion. Upon the addition of BC with thorough stirring and readjustment to neutral pH, BC was effectively embedded within SPI molecules, inhibiting conformational recovery and forming stable molten globule SPI-BC co-assemblies. These co-assemblies exhibited a markedly increased particle size (270 μm) and a substantially enhanced surface hydrophobicity (6 233). During heat-induced gelation, SPI-BC co-assemblies displayed a “premature initiation” gelation behavior, with storage modulus (G') beginning to rise sharply at 70 ℃, considerably lower than the gelation onset temperature of native SPI. CLSM observation revealed that native SPI required structural unfolding prior to crosslinking to form a three-dimensional network gel, whereas SPI-BC co-assemblies underwent direct crosslinking to form a dense and homogeneous three-dimensional network structure. LF-NMR results further confirmed that the SPI-BC co-assemblies gel exhibited the shortest immobile water relaxation time (75.64 ms), indicating a positive correlation between the compactness of the gel network and its water-holding capacity. 【Conclusion】 pH-shifting treatment promoted the entanglement of SPI with BC to form stable co-assemblies by modulating SPI conformational transitions. The molten globule-like co-assemblies underwent direct crosslinking during heating, forming a dense and uniformly distributed three-dimensional gel network.

Key words: protein-polysaccharide interaction, molecular conformation, microstructure, gel properties, pH-shifting treatment, molten globule co-assemblies