The use of hybrid wheat is one way to improve the yield in the future.  However, greater plant heights increase lodging risk to some extent.  In this study, two hybrid combinations with differences in lodging resistance were used to analyze the stem-related traits during the filling stage, and to investigate the mechanism of the difference in lodging resistance by analyzing lignin synthesis of the basal second internode (BSI).  The stem-related traits such as the breaking strength, stem pole substantial degree (SPSD), and rind penetration strength (RPS), as well as the lignin content of the lodging-resistant combination (LRC), were significantly higher than those of the lodging-sensitive combination (LSC).  The phenylpropanoid biosynthesis pathway was significantly and simultaneously enriched according to the transcriptomics and metabolomics analysis at the later filling stage.  A total of 35 critical regulatory genes involved in the phenylpropanoid pathway were identified.  Moreover, 42% of the identified genes were significantly and differentially expressed at the later grain-filling stage between the two combinations, among which more than 80% were strongly up-regulated at that stage in the LRC compared with LSC.  On the contrary, the LRC displayed lower contents of lignin intermediate metabolites than the LSC.  These results suggested that the key to the lodging resistance formation of LRC is largely the higher lignin synthesis at the later grain-filling stage.  Finally, breeding strategies for synergistically improving plant height and lodging resistance of hybrid wheat were put forward by comparing the LRC with the conventional wheat applied in large areas.

With the application of hybrid wheat, lodging is becoming one of the major factors limiting high yield in its production.  However, few studies have focused on combining ability and heterosis analysis of stem-related traits.  In this study, 24 crosses were made according to NCII genetic design, using the three (photo-sensitive male sterile lines)×eight (restorer lines) incomplete diallel crosses.  The length of basal second internode (LBSI) and breaking strength of basal second internode (BSBSI) as well as other stem-related traits were used to perform the principal component analysis (PCA), combining ability and heterosis analysis.  The PCA results showed that the variables could be classified into two main factors, which were named as the positive factor (factor 1) and the negative factor (factor 2), and accounted for 52.3 and 33.2%, respectively, of the total variance in different variables, combined with the analysis for index weight indicated that the factor 1-related traits play positive roles in lodging resistance formation of hybrids.  Combining ability variance analysis indicated that its genetic performance was mainly dominated by additive gene effects, and the hybrid combinations with higher lodging resistance can be selected by using of 14GF6085 (R1), 14GF6343-2 (R4), 14GF6937 (R6), 14GF7433-1 (R7), and BS1086 (M3), which are with the features with lower general combining ability (GCA) effects of factor 2-related traits whereas higher GCA effects of factor 1-related traits.  The heterosis analysis showed that the wide range of heterosis varied with the traits and combinations, and GCA or specific combining ability (SCA) effects of factor 1-related traits except wall thickness of basal second internode (WTBSI) were positively and closely related to the heterosis of lodging resistance.  Generally, the correlation coefficients of heterosis to GCA effects of sterile lines (GCA_m) of factor 1-related traits are significantly higher than that to GCA of restorer lines (GCA_r) and SCA, combined with the higher GCA_m variance values of factor 1-related traits compared to GCA_r, the GCA_m of factor 1-related traits should be particularly considered when breeding hybrid combinations.  The heritability analysis showed that the narrow-sense heritability of the diameter of basal second internode (DBSI) and the center of gravity height (TCGH) were obviously lower (<60%) than other traits, suggesting that these two traits were suitable for selection in higher generation for parental breeding.  These could provide a theoretical basis for parental breeding and heterosis utilization of lodging resistance. 

Because of the yield increase of 3.5–15% compared to conventional wheat, hybrid wheat is considered to be one of the main ways to greatly improve the wheat yield in the future.  In this study, we performed a principal component analysis (PCA) on two-line hybrids wheat and their parents using the grain weight (GW), the length of spike (LS), the kernel number of spike (KSN), and spike number (SPN) as variables.  The results showed that the variables could be classified into three main factors, the weight factor (factor 1), the quantity factor 1 (factor 2) and the quantity factor 2 (factor 3), which accounted for 37.1, 22.6 and 18.5%, respectively of the total variance in different agronomic variables, suggesting that the GW is an important indicator for evaluating hybrid combinations, and the grain weight of restorer line (RGW) could be used as a reference for parents selection.  The hybrid combination with a higher score in factor 1 direction and larger mid-parent heterosis (MPH) of the GW and its parents were used to carry out the analysis of grain filling, 1-aminocylopropane-1-carboxylicacid (ACC) and polyamine synthesis related genes.  The results suggested that the GW of superior grain was significantly higher than that of inferior grains in BS1453×JS1 (H) and its parents.  Both grain types showed a weight of H between BS1453 (M) and JS1(R), and a larger MPH, which may be caused by their differences in the active filling stage and the grain filling rate.  The ADP-glucose pyrophosphorylase (AGPase), granule bound starch synthase I (GBSSI), starch synthase III (SSS), and starch branching enzyme-I (SBE-I) expression levels of H were intermediated between M and R, which might be closely related to MPH formation of the GW.  Compared with R and H, the GW of M at maturity was the lowest.  The expression levels of spermidine synthase 2 (Spd2), ornithine decarboxylase (ODC) and S-adenosylmethionine decarboxylase (SAMDC) had significantly positive correlations with the grain filling rate (r=0.77*, 0.51*, 0.59*), suggesting their major roles in the grain filling and heterosis formation.  These provide a theoretical basis for improving the GW of photo-thermo-sensitive male sterile lines (PTSMSL) by changing the endogenous polyamine synthesis in commercial applications.

Two wheat cultivars (Triticum aestivum L.) were used to evaluate the effects of post-anthesis severe water deficit (SD) on starch content and granule size distribution and their relations with ethylene and spermidine (Spd). Comparison to the well-watered (WW) treatment, SD led to lower Spd and higher 1-aminocylopropane-1-carboxylic acid (ACC) concentrations and ethylene evolution rate (EER) in grains at the critical stage of forming starch granules. Application of Spd or aminoethoxyvinylglycine (AVG) significantly reduced ACC concentration and EER and increased Spd concentration, while ethephon or methylglyoxal-bis (MGBG) had an opposite impact. The volume and surface area distribution of starch granules showed a bimodal curve, while the number distribution exhibited a unimodal curve. SD caused a marked drop in grain weight, grain number and starch content, also led to a significant reduction in the proportion (both by volume and by surface area) of B-type starch granules (<10 μm), with an increase in those of A-type starch granules (>10 μm). Application of Spd or AVG increased the proportion (both by volume and by surface area) of B-type starch granules under SD. Correlation analysis suggested that ethylene and Spd showed an antagonism relation in the formation of B-type granules. These results suggested that it would be good for the formation of B-type starch granules to have the physiological traits of higher Spd and lower ACC concentrations and ethylene emission under SD.

Granule size distribution of wheat starch is an important characteristic that can affect its chemical composition and the functionality of wheat products. Two high-yield winter wheat cultivars were used to evaluate the effects of the application of exogenous ABA or GA during the reproductive phase of the initial grain filling on starch granule size distribution and starch components in grains at maturity. The results indicated that a bimodal curve was found in the volume and surface area distribution of grain starch granules, and a unimodal curve was observed for the number distribution under all treatments. The exogenous ABA resulted in a significant increase in the proportions (both by volume and by surface area) of B-type (<9.9 μm in diameter) starch granules, with a reduction in those of A-type (>9.9 μm) starch granules, while, the exogenous GA3 led to converse effects on size distribution of those starch granules. The exogenous ABA also increased starch, amylose and amylopectin contents at maturity but significantly reduced the ratio of amylose to amylopectin. Application of GA3 significantly reduced starch content, amylopectin content but increased the ratio of amylose to amylopectin. The ratio of amylose to amylopectin showed a significant and negative relationship with the volume proportion of granules <9.9 μm, but was positively related to the volume proportion of granules 22.8-42.8 μm.